HP Jet Fusion 4200 - Electrical Installation Checklist

Electrical installation Yes No Comments
Has the site been prepared to supply power to the printer?
Conguration 1 branch circuit breaker: 4 poles, 32/40 A
Conguration 2 branch circuit breaker: 3 poles, 50/60 A
(Required)
Has the site been prepared to supply power to the processing station?
Conguration 1 branch circuit breaker: 2 poles, 25 A, type J
Conguration 2 branch circuit breaker: 2 poles, 20 A, type J
(Required)
Is the chosen power system within its nominal range? (Required)
Is the grounding conductor properly installed, as shown in the site preparation
guide?
(Required)
Have you booked the services of a certied electrician for the rst two days of
installation? (May be required on the rst or second day.)
(Required)
Is the electrician aware of all requirements and specications highlighted in this
document?
(Required)
Is the Power Distribution Unit (PDU) correctly installed? (Required)
Are Residual-Current Circuit Breakers (RCCB), also known as Ground Fault Circuit
Interrupters (GFCI), required by local laws? if so, have they a sensitivity of 100 mA
or higher?
Electrical conguration Yes No Comments
No power cords are supplied with the printer/processing station; does the
electrician understand that power cord(s) must be provided according to
equipment specications and local laws?
(Required)
If local regulations specify that you must use electrical plugs to connect the
printer/processing station to the power supply, does the electrician have the
required plugs ready for installation?
(Required)
If you are using a UPS, does it follow the requirements in the site preparation
guide? See How to select an external power supply on page 20.
Networking requirements Yes No Comments
Have network connections been supplied? (Required)
Do you have a LAN cable long enough to connect the printer and the processing
station to the network?
(Required)
Do you have a computer in which we can install the HP SmartStream Command
Center?
(Required)
Will the above computer be permanently connected to the Internet and
permanently powered on?
(Required)
Have you installed the HP SmartStream Command Center Software in one
computer and tested the connection to the HP Cloud as specied in this guide?
(Required)
ENWW 51