HP Kayak XU800 Service Handbook

HP Kayak XU800 PC Workstation
1-14 HP Kayak XU800 PC Workstation Minitower
PC Workstations
1
Mass Storage Device Guide Rails
Attached on the side of the front access cage, additional guide rails are available
for mass storage device installations. Depending on the device to be installed,
dedicated guide rails are required and are easily recognized by their distinct size
and color.
The following table indicates the device, location, and required rails.
Device to be
Installed
Location Required
Rails
Installing the Rails
3.5-inch device
(hard disk drive)
3.5-inch
internal
shelf (two
shelves)
Short blue left
and right rails
Insert the guide rail labeled “L”
on the left-hand side (cable
connectors facing towards you
and positioned at the bottom),
and the guide rail “R” on the
right-hand side of the hard disk
drive.
5.25-inch device
(CD-ROM, etc.)
5.25-inch
front
access
cage shelf
Long green rails There is no specific side to
which these guides must be
installed. However, they must
be inserted in the two holes
located at the bottom of the
drive.
Third 3.5-inch hard disk
drive
Hard disk drive is mounted on
the pre-installed 5.25-inch
hard disk drive tray and
secured to the tray using the
supplied four screws.
3.5-inch device
(zip drive
Short green left
and right rails
Carefully break off the metal
plate from the chassis. Insert
the guide rail labeled “L” on
the left-hand side (cable
connectors facing towards you
and positioned at the top), and
the guide rail “R” on the right-
hand side of the hard disk
drive.
Ka_sh_1.bk Page 14 Thursday, June 15, 2000 7:27 PM

HP Kayak XU800 Specifications

General

Brand	HP
Model	Kayak XU800
Category	Desktop
Language	English