HP Kayak XU800 Service Handbook

A-2 Beep, POST, and Error Codes
A
Beep Codes for the HP Kayak XU800
Number
of
Beeps
Description Action to Take...
1 The memory refresh
circuitry is faulty.
Check that:
• Memory is installed correctly.
• Correct memory modules are being used.
If the error still occurs, replace the memory.
2 Parity error in the base
memory (the first 64 KB
block) of memory.
3 Memory error.
4 Clock error. • Check that the system board is correctly
cabled (power cables, processor and
terminator).
If the error still occurs, replace the system
board.
5 Processor test error. Check that:
• Processor is correctly installed.
• Termination card installed in processor
slot 2 in a single processor system.
If the error still occurs, replace:
1Processor.
2 system board.
6 Input/Output (I/O) error. • Keyboard is connected.
• PCI card is installed correctly.
• Termination card installed in processor
slot 2 in a single processor system.
7 The processor on the
system board generated
an error.
• There is an installed processor(s).
• Processor(s) is correctly installed in the
processor slot(s).
• Two installed processors have the same
cache size (256 k).
• Termination card is installed in processor
slot 2 in a single processor system.
• VRM is installed in the VRM socket in a
dual processor system.
If the error still occurs, replace the system
board.
8 The system video card is
either missing or faulty.
This is not a fatal error. Check that the video
card is correctly installed and cabled. If
missing, install the video card. If the error
still occurs, replace it with a known working
video card.
Ka_sh_1.bk Page 2 Thursday, June 15, 2000 7:27 PM

HP Kayak XU800 Specifications

General

Brand	HP
Model	Kayak XU800
Category	Desktop
Language	English