Install the product on a wired network
Configure the IP address
1. Connect the network cable to the product and to the network.
2. Wait for 60 seconds before continuing. During this time, the network recognizes the product and
assigns an IP address or host name for the product.
3. At the product control panel, press the Home button
.
4. Press the down arrow
to highlight the Administration menu, and then press the OK button.
5. Press the down arrow
to highlight the Reports menu, and then press the OK button.
6. Press the down arrow
to highlight the Configuration/Status Pages menu, and then press
the OK button.
7. Press the down arrow
to highlight the Configuration Page item, and then press the OK
button.
8. Press the up arrow
to highlight the Print option, and then press the OK button to print the
report.
9. Find the IP address on the Embedded Jetdirect page.
HP Color LaserJet CP5525 Printer
Embedded Jetdirect Page
10. IPv4: If the IP address is 0.0.0.0, or 192.0.0.192, or 169.254.x.x, you must manually configure
the IP address. See
Manually configure IPv4 TCP/IP parameters from the control panel
on page 67. Otherwise, the network configuration was successful.
64 Chapter 5 Connect the product ENWW
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...