Table 8-2 Control-panel light patterns (continued)
Light status Error code State of the product Action
Attention light is blinking.
E0 Paper is jammed in the printer. Clear the jam.
E1 The input tray is empty. Load the tray.
E2 A door is open. Verify that the toner-cartridge
door is fully closed.
E4 The toner cartridge is very low. Press the Start Copy button to
continue or replace the toner
cartridge.
E5 The toner cartridge is very low. Replace the toner cartridge.
H0 The printer is in manual-feed
mode.
Load the correct paper type
and size into the input tray.
Press the Start Copy button to
continue.
H1 The printer is processing a
manual duplex job.
Load the pages into the input
tray to print the second sides.
Press the Start Copy button to
continue.
The attention and toner lights
are blinking.
E3 The toner-cartridge is missing
or is not installed correctly.
Install the toner-cartridge.
The toner light is on.
The toner-cartridge has
reached the end of its
estimated useful life. When the
supply has reached this
condition, the HP Premium
Protection warranty for that
supply has ended.
You do not need to replace the
toner-cartridge at this time
unless print quality is no longer
acceptable.
The attention and ready lights
are on.
E6
E7
E8
E9
The printer has experienced a
fatal error from which it cannot
recover.
1. Turn off the printer or
disconnect the power
cord from the printer.
2. Wait 30 seconds, and
then turn on the printer or
reconnect the power cord
to the printer.
3. Wait for the printer to
initialize.
If the error persists, contact HP
customer support.
70 Chapter 8 Solve problems ENWW
To Next Page
Loading...