Framing a group of displays is similar to framing a single display except that you will use some of the
straight connectors to cover the gap between adjacent displays.
Figure 3-12 Framing an array
Attach corners and straight connectors after the rails are in place.
Figure 3-13 Attaching corners and connectors
When you frame an array, the peripheral displays can no longer move independently. For this reason,
the following tasks may best be done before framing:
●
Color Calibration
●
Attaching all cables
●
Putting the main power switch in the ON (|) position
●
Horizontal, vertical and depth adjustment of all displays
14 Chapter 3 Setting up the display ENWW
To Next Page
Loading...
