Protecting playback
To prevent the loss of playback or playback quality, Do not connect or disconnect hardware while playing
a disc.
To prevent the loss of playback while the computer is operating in Windows, do not initiate standby or
hibernation while playing a disc. Otherwise, you may see the warning message “Putting the computer
into hibernation or standby might stop the playback. Do you want to continue?” If this message is
displayed, click No.
After you click No:
●
Playback may resume.
– or –
●
Playback may stop and the screen may clear. To return to playing the CD or DVD, press the power
button and then restart the disc.
Protecting the CD or DVD write process
CAUTION To prevent loss of information or damage to a disc:
Before writing to a disc, connect the computer to a reliable external power source. Do not write
to a disc while the computer is running on battery power.
Before writing to a disc, close all open programs except the disc software you are using.
Do not copy directly from a source disc to a destination disc or from a network drive to a
destination disc. Instead, copy from a source disc or network drive to your hard drive, and then
copy from your hard drive to the destination disc.
Do not use the computer keyboard or move the computer while the computer is writing to a disc.
The write process is sensitive to vibration.
24 Chapter 2 Multimedia software ENWW
To Next Page
Loading...
