Slide the duplexer into the back of the printer until the unit locks into place. Do not press
the buttons on either side of the duplexer when installing the unit; use them only for
removing the unit from the printer.
Install Tray 2
Tray 2 can hold up to 250 sheets of plain paper. For ordering information, see HP supplies
and accessories.
To install Tray 2
1. Unpack the tray, remove the packing tapes and materials, and move the tray to the
prepared location. The surface must be sturdy and level.
2. Turn off the printer, and disconnect the power cord.
3. Set the printer on top of the tray.
CAUTION: Be careful to keep your fingers and hands clear of the bottom of the
printer.
4. Connect the power cord and turn on the printer.
5. Enable Tray 2 in the printer driver. For more information, see
Turn on accessories in
the printer driver.
Chapter 1
28 Get started
To Next Page
Loading...