HP OMEN 25i FHD Gaming

3. In the OSD, select Input and then select PIP.
The monitor scans the secondary inputs for a valid signal input and uses that input for the PiP or PbP
picture.
4. If you want to change the PiP or PbP input, select PIP in the OSD, and then select Assign Inputs.
5. If you want to change the size of the PiP, select PIP Size in the OSD, and then select the size that you
want.
6. If you want to adjust the position of the PiP, select PIP Position in the OSD, and then select the position
that you want.
18 Chapter 2 Using the monitor