EasyManuals Logo

HP OMEN 34c User Manual

HP OMEN 34c
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
17
IMPORTANT:
Repair Condition: Connector repair is only for out of warranty.
Repairing must operate by professional repairers (Note) in repair center, not applicable for end user.
Electrostatic protection is required when component replacement is required.
The monitor meets ROHS, please use Lead-free solder wire for soldering.
If Connector need to replace, must check specification and part number whether match the BOM and location.
If connector need to replace, please insert new parts carefully because the near pin may cause short circuit by
inappropriate operate.
DO NOT allow any liquid on the board. Water and moisture may cause short-circuit to the electronic components and
lead to malfunctions.
The fusion point of Lead-Free solder is requested. Repairing with conventional lead wire may cause damage.
Work quickly to avoid overheating the circuit board as soon as you confirm the steady soldering condition.
Keep the soldering iron tip clean and well tinned and when replacing parts.
A close inspection of the circuit board revealed look in good condition.
After repaired, must connect source to each port to check Main board function is ordinary.
Note: (The requirement of professional repairers regulation by ERP lot5)
1) The professional repairer has the technical competence to repair electronic displays and complies with the
applicable regulations for repairers of electrical equipment in the Member States where it operates. Reference to
an official registration system as professional repairer, where such system exists in the Member States
concerned, shall be accepted as proof of compliance with this point.
2) The professional repairer is covered by insurance covering liabilities resulting from its activity, regardless of
whether this is required by the Member State.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP OMEN 34c and is the answer not in the manual?

HP OMEN 34c Specifications

General IconGeneral
Haze rate40 %
Panel typeVA
Color gamut90 %
Pixel pitch0.23 x 0.23 mm
Pixel density110 ppi
Backlight typeEdge LED
Display diagonal34 \
Surface hardness3H
Anti-glare screenAlways gives an optimal view, even in direct sunlight.
Display technologyLED
Native aspect ratio21:9
Vertical scan range60 - 165 Hz
Horizontal scan range30 - 255 kHz
Screen curvature rating1500R
Viewable size, vertical333.7 mm
sRGB coverage (typical)99 %
Display number of colors16.7 million colors
Viewable size, horizontal797.2 mm
Display brightness (typical)400 cd/m²
Supported graphics resolutions640 x 480 (VGA), 720 x 400, 800 x 600 (SVGA), 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 720 (HD 720), 1280 x 800 (WXGA), 1440 x 900 (WXGA+), 1600 x 900, 1680 x 1050 (WSXGA+), 1920 x 1080 (HD 1080), 1920 x 1200 (WUXGA), 2560 x 1440, 3440 x 1440
High Dynamic Range (HDR) supportedYes
DisplayPort version1.4
Headphone connectivity3.5 mm
AC input voltage100 - 240 V
Power supply typeInternal
AC input frequency50 - 60 Hz
Energy efficiency scaleA to G
Power consumption (max)90 W
Power consumption (standby)0.5 W
Power consumption (typical)76 W
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)20 - 80 %
Package depth227 mm
Package width911 mm
Package height465 mm
Package weight15390 g
Tilt angle range-5 - 20 °
Height adjustment100 mm
Panel mounting interface100 x 100 mm
Cables includedAC
CertificationBIS; BSMI; CB; CCC; CE; CEL; CSA; EAC; FCC; ISO 9241-307; KC/KCC; Microsoft WHQL Certification; NOM; PSB; TUV Bauart; TUV LBL; VCCI; WEEE; ISC; California Energy Commission (CEC); WW application; ICE; Ukraine certificates; TÜV Flicker free certified; UAE safety; UAE RoHS; South Africa safety
Product colorBlack
Market positioningGaming
AMD FreeSync typeFreeSync Premium
RMS rated power6 W
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)243.3 mm
Width (with stand)807.9 mm
Height (with stand)584 mm
Weight (with stand)10590 g
Depth (without stand)108.4 mm
Height (without stand)366.7 mm

Related product manuals