Setting up the monitor
WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper
workstation setup and proper posture, health, and work habits for computer users. The Safety & Comfort
Guide also provides important electrical and mechanical safety information. The Safety & Comfort Guide is
available on the Web at http://www.hp.com/ergo.
IMPORTANT: To prevent damage to the monitor, do not touch the surface of the LCD panel. Pressure on the
panel can cause nonuniformity of color or disorientation of the liquid crystals. If this occurs, the screen will
not recover to its normal condition.
IMPORTANT: To prevent the screen from getting scratched, defaced, or broken and to prevent damage to
the control buttons, position the monitor facedown on a at surface covered with protective sheet foam or a
nonabrasive cloth.
Installing the stand
1. Position the monitor facedown on a at surface covered by a soft clean cloth.
2. Remove the bag containing the allen tool from the back of the monitor stand (1). Slide the hinge on the
stand into the hinge slot on the back of the monitor head and push down to secure it (2). There will be an
audible click when the stand is properly seated onto the hinge. Use the allen tool to tighten the two
screws on the underside of the monitor’s hinge slot (3). Be sure that the stand is properly secured to the
monitor head before use.
4 Chapter 1 Getting started
To Next Page
Loading...
