HP OmniBook XE2 - To Delete a Password; To Attach a Security Cable

Operating the OmniBook XE2
Protecting the OmniBook
2-17
To delete a password
1. From the Start menu, shut down, then restart the OmniBook.
2. When you see the HP logo, press F2 to enter the BIOS Setup utility.
3. Select the Security menu.
4. Select Set Supervisor Password, then press ENTER.
5. Type the current password, then press ENTER.
6. Press ENTER at the Enter New Password prompt.
7. Press ENTER at the Confirm New Password prompt.
8. Press Continue.
9. Press F10 to Save and Exit the BIOS Setup utility.
To attach a security cable
Your OmniBook has a built-in connector that allows you to secure the
OmniBook with a cable. The Kensington MicroSaver lock system works with
this connector and is available at many computer stores.
1. Wrap the cable around a stationary object, such as a table leg.
2. Loop the cable to create a slip knot around the stationary object—make
sure it can’t slip off
3. Insert the lock into one of the OmniBook security connectors and release
the key. Store the key in a safe place away from the OmniBook.