Using Windows 95
Installing Windows 95
5-9
11. Enter \OMNIBOOK\DRIVERS\IRDA\SETUP and click OK.
12. Click Next.
13. Click Next to accept the default IR device.
14. Select the Generic IR Serial Port (COM2) and click Next.
15. Click Next to accept the default ports (COM4 and LPT3).
16. Click Finish.
17. Click Yes to restart the computer.
Note
This may cause a conflict between the Infrared port and the built-in modem. To
resolve the conflict do the following:
1. From the Control Panel, open System then Device Manager.
2. If the ESS ES56CVH-PI Data Fax Voice Modem has an exclamation
point, double-click it.
3. Click Resources.
4. Click Set Configuration Manually.
5. Click OK.
To install USB Support for Windows 95
If you’ve installed Windows 95 and you wish to use USB, you’ll need to install
USB support. These drivers expand from the web package to its default
location in \OMNIBOOK\DRIVERS\W95\USB.
1. Copy the \OMNIBOOK\DRIVERS\W95\USB directory and its contents
from to C:\WINDOWS\TEMP.
2. Open the MS-DOS Prompt.
3. Type: CD TEMP\USB and press Enter.
4. Type: ATTRIB –R *.* /S and press Enter.
5. Type: OEMUSB /Q:1 /T:C:\WINDOWS\TEMP\USB\USB1 /N:E and
press Enter.
6. Type: USBUPD2 /Q:1 /T:C:\WINDOWS\TEMP\USB\USB2 /N:E and
press Enter.
7. From Control Panel, double-click System, then click Device Manager.
8. Remove the PCI Universal Serial Bus Device under Other Devices.
9. Close System Properties.
10. Shutdown and restart the OmniBook.
To Next Page
Loading...
