EasyManuals Logo

HP P2000 G3 MSA User Manual

HP P2000 G3 MSA
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
52 Event descriptions
431
Error Replication to the indicated secondary volume has suspended due to an error on that volume. User
intervention is required to resume replication. This can occur for several reasons, such as:
The cache request was aborted.
The cache detected that the source or target volume is offline.
The cache detected a media error.
The snap pool is full.
The communication link is busy or experienced an error.
The snapshot being used for the replication is invalid.
There was a problem establishing proxy communication.
Recommended actions
Resolve the error and then resume the replication.
432
Error Aborted a replication due to an error on the indicated secondary volume.
Recommended actions
Verify that the secondary volume is valid and that the system where the volume resides is accessible.
433
Info. Skipped a replication to the indicated secondary volume.
Recommended actions
No action is required.
434
Warning A replication collided with an ongoing replication to the indicated secondary volume.
A replication was in progress for the replication set when a new replication was requested. The new
replication has been queued.
Recommended actions
This can be a normal operation, but in some cases this can indicate a problem. Ensure that: there are
no network issues; there is sufficient bandwidth between the primary and secondary systems; the
interval between replications is set to a sufficient amount of time to allow replications to complete.
Having too many replications queued can result in some replications not completing.
435
Warning Failed to initialize the indicated replication set.
This can occur because:
Firmware in the remote system is incompatible with firmware in the local system.
The primary volume and secondary volume involved in replication cannot communicate.
Recommended actions
Update the firmware on one or both systems so they are running the same version.
Check your network or fabric for abnormally high congestion or connectivity issues.
436
Warning Firmware in the remote system is incompatible with firmware in the local system so they cannot
communicate with each other to perform replication operations.
Recommended actions
Update the firmware on one or both systems so they are running the same version.

Other manuals for HP P2000 G3 MSA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP P2000 G3 MSA and is the answer not in the manual?

HP P2000 G3 MSA Specifications

General IconGeneral
ModelHP P2000 G3 MSA
Form Factor2U
Drive TypesSAS, SATA
ControllersDual controllers
Host InterfaceSAS, iSCSI, Fibre Channel
RAID Levels0, 1, 5, 6, 10
ManagementWeb-based, CLI
Cache Memory2 GB per controller

Related product manuals