HP P2000 G3 MSA User Manual

54 Event descriptions
442
Warning Power-On Self Test (POST) diagnostics detected a hardware error in a UART chip in either or both of the
controllers.
Recommended actions
• Replace the controller module that logged this event.
443
Warning A firmware version mismatch has been detected in an MSA70 or D2700 enclosure. The enclosure should
be updated to the latest supported version of firmware as soon as possible.
Recommended actions
• In the enclosure, all FRUs must be at a combined proper firmware recipe. The two expansion modules
must be at equal firmware versions. Any replaced MSA70 FRUs might have older firmware that does
not match an internally defined recipe. Update the indicated enclosure to the latest firmware version to
ensure all FRUs are at the proper firmware level.
444
Warning A snap pool reached a capacity threshold and the associated Auto Expand policy failed because there is
not enough available space in the vdisk.
Recommended actions
• Increase the available space in the vdisk either by expanding the vdisk or by removing any unneeded
volumes.
Info. A snap pool reached a capacity threshold and the associated policy completed successfully; for example,
the snap pool was expanded successfully, or the oldest snapshot was deleted, or all snapshots were
deleted. If the policy is Delete Oldest Snapshot, the serial number of the deleted snapshot is reported.
Recommended actions
• No action is required.
449
Info. Rollback was aborted for the indicated master volume.
This can occur if a rollback is in progress and a user selects to roll back a different volume, which will abort
the first rollback and start a new rollback. A user can't explicitly abort a rollback because that would
corrupt the master volume.
Recommended actions
• No action is required.
450
Warning A remote volume’s status changed from online to offline.
This can occur for several reasons, such as:
• The communication link is busy or experienced an error.
• The local initiator experienced an error.
Recommended actions
• Verify that there are no network issues preventing communication between the local and remote storage
systems.

HP P2000 G3 MSA Specifications

General

Model	HP P2000 G3 MSA
Form Factor	2U
Drive Types	SAS, SATA
Controllers	Dual controllers
Host Interface	SAS, iSCSI, Fibre Channel
RAID Levels	0, 1, 5, 6, 10
Management	Web-based, CLI
Cache Memory	2 GB per controller