Solid-state drive (M.2)
Description Spare part number
Solid-state drive, 128 GB, SATA-3. TLC 759848-032
Solid-state drive, 128 GB, SATA-3, Value 827560-017
Solid-state drive, 256 GB, PCIe 3x4 SS, TLC 847109-005
Solid-state drive, 512 GB, PCIe 3x4 SS, TLC 847110-002
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see Base enclosure on page 32).
5. Disconnect the cable from the battery.
Remove the solid-state drive:
▲
Remove the Phillips screw (1), and then pull the solid-state drive away from the connector (2).
Reverse this procedure to install the solid-state drive.
Component replacement procedures 39
To Next Page
Loading...
Need help?
General