To Next Page

To Previous Page

NOTE: The external optical drive must be connected to a USB port on the computer, not to a

USB port on another external device, such as a hub or docking station.

NOTE: DVDs and DVDs with double-layer (DL) support store more information than CDs, so

using them for backup reduces the number of recovery discs required.

●

When backing up to discs, number each disc before inserting it into the optical drive of the computer.

Using Windows Backup and Restore

To create a backup using Windows Backup and Restore, follow these steps:

NOTE: Be sure that the computer is connected to AC power before you start the backup process.

NOTE: The backup process make take over an hour, depending on file size and the speed of the

computer.

1. Select Start > All Programs > Maintenance > Backup and Restore.

2. Follow the on-screen instructions to set up and create a backup.

NOTE: Windows® includes the User Account Control feature to improve the security of your computer.

You may be prompted for your permission or password for tasks such as installing software, running

utilities, or changing Windows settings. Refer to Help and Support for more information.

Using system restore points

When you back up your system, you are creating a system restore point. A system restore point allows

you to save and name a snapshot of your hard drive at a specific point in time. You can then recover

back to that point if you want to reverse subsequent changes made to your system.

NOTE: Recovering to an earlier restore point does not affect data files saved or e-mails created since

the last restore point.

You also can create additional restore points to provide increased protection for your system files and

settings.

When to create restore points

●

Before you add or extensively modify software or hardware

●

Periodically, whenever the system is performing optimally

NOTE: If you revert to a restore point and then change your mind, you can reverse the restoration.

Create a system restore point

1. Select Start > Control Panel > System and Security > System.

2. In the left pane, click System Protection.

3. Click the System Protection tab.

4. Under Protection settings, select the disk for which you want to create a restore point.

5. Click Create.

6. Follow the on-screen instructions.

78 Appendix B Backup and recovery

Downloaded from LpManual.com Manuals

HP PAVILION DM3 User Manual

Other manuals for HP PAVILION DM3