Hard drive
NOTE: The hard drive spare part kit does not include the hard drive connector cable, hard drive
bracket, or screws. The hard drive connector cable is included in the Cable Kit, spare part number
652696-001.
Description Spare part number
1-TB, 5400-rpm, 12.7-mm 638974-001
750-GB, 7200-rpm, 7.0-mm 633252-001
750-GB, 5400-rpm, 7.0-mm 634250-001
640-GB, 7200-rpm, 7.0-mm 621046-001
500-GB, 7200-rpm, 7.0-mm 634925-001
320-GB, 7200-rpm, 7.0-mm 634862-001
Hard Drive Hardware Kit (includes hard drive bracket and screws) 653525-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 41).
5.
Remove the memory module/wireless module compartment cover (see
WLAN module
on page 44).
Remove the hard drive:
1.
Loosen the captive screw (1) that secures the hard drive compartment cover to the computer.
Component replacement procedures
55
To Next Page
Loading...
