Setting a DriveLock password
To set a DriveLock password:
1. Open the Setup Utility by turning on the computer, and then pressing f10 while the setup
message is displayed in the lower-left corner of the screen.
2. Use the arrow keys to select one of the following options:
●
If the computer has one hard drive, select Security > DriveLock Password, and then
press enter. (This option is called Primary DriveLock Password on models with two hard
drives.)
– or –
●
If you want DriveLock protection on the secondary hard drive (select models only), select
Security > Secondary DriveLock Password, and then press enter.
3. Read the warning, and then press enter.
4. Type your password in the Enter New Password field, and then press enter.
5. Type your password again in the Confirm New Password field, and then press enter.
6.
To confirm DriveLock protection on the drive you have selected, type DriveLock in the
confirmation field, and then press enter.
7. Press enter to continue.
8. To save your preferences and exit the Setup Utility, press f10, and then follow the instructions
on the screen.
Your preferences go into effect when the computer restarts.
138 Chapter 11 Security ENWW
To Next Page
Loading...
Need help?
General
