Setup Utility language
To select a language:
1. Open the Setup Utility by turning on or restarting the computer, and then pressing f10 while the
“Press <F10> to enter setup” message is displayed in the lower-left corner of the screen.
2. Use the arrow keys to select Advanced > Language Support, and then press enter.
3. Press f5 or f6 to change a language, or press enter to select a language.
4. Save your preferences and exit the Setup Utility:
●
Use the arrow keys to select Exit > Exit Saving Changes, press enter, and then follow the
instructions on the screen.
– or –
●
Press f10, and then follow the instructions on the screen.
Your preferences go into effect when the computer restarts.
144 Chapter 12 Setup Utility ENWW
To Next Page
Loading...
