1. Release the ZIF connector (1) to which the display panel cable cable is attached, and then disconnect the
display panel cable from the display panel assembly.
2. Release the ZIF connector (2) to which the display panel cable is attached, and then disconnect the
display panel cable from the system board.
3. Remove the display panel cable (3).
Reverse this procedure to install the display panel cable.
Power connector cable
Description Spare part number
Power connector cable 802829-001
Before removing the power connector cable, follow these steps:
1. Turn o the tablet. If you are unsure whether the tablet is o or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see Back cover on page 23).
5. Disconnect the battery cable from the system board (see Battery on page 24).
Remove the power connector cable:
34 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
