Fingerprint reader
Description Spare part number
Fingerprint reader 683652-001
Before removing the fingerprint reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 38)
b. Bottom door (see
Bottom door on page 39).
c. Hard drive (see
Hard drive on page 43)
d. Optical drive (see
Optical drive on page 40)
e. Memory (see
Memory modules on page 45)
f. WLAN module (see
WLAN/Bluetooth combo card on page 47)
g. Keyboard (see
Keyboard on page 49)
h. Metal heat shield (see
Metal heat shield on page 51)
i. Fan (see
Fan on page 52)
j. Top cover (see
Top cover on page 53)
Remove the fingerprint reader:
1. Position the top cover upside-down with the front toward you.
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the device to the top cover.
3. Slide the fingerprint reader out of the retainer (2).
Component replacement procedures 61
To Next Page
Loading...
