2. Disconnect the main power cable (1), display cable (2), and the audio cable (3) from the system
board.
3. Remove the two Phillips PM2.5×4.0 screws (1) that secure the system board then, lift the system
board (2) to access the battery cable connector.
Remove the battery cable.
The battery cable is included in the Cable Kit, spare part number 683640-001.
1. With the system board at an angle, disconnect the battery cable (1) from the bottom of the
board.
NOTE: The system board may now be safely removed.
2. Remove the two screws (2) that secure the connector to the base assembly.
68 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
