1. Remove display cable from the clips (1) on the side of the fan.
2. Remove the three Phillips 2.0 × 4.0 screws (2) that secure the fan to the computer.
3. Disconnect the fan cable from the system board (3).
4. Remove the fan from the computer (4).
To install the fan assembly, reverse this procedure.
Fingerprint reader board
To remove the fingerprint reader board, use this procedure and illustration.
Table 6-6
Fingerprint reader board description and part number
Description Spare part number
Fingerprint reader board N00879-001
Fingerprint reader board cable (included in Cable Kit) N03218-001
Fingerprint reader board bracket (included in Bracket Kit) N01916-001
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 37).
2. Remove the bottom cover (see Bottom cover on page 37).
3. Disconnect the battery cable from the system board (see Battery on page 46).
4. (Select products only) Remove the WWAN module (see WWAN module on page 42).
Remove the fingerprint reader board:
1. Disconnect the cable from the ZIF connector (1) on the fingerprint reader board.
Fingerprint reader board
51
To Next Page
Loading...
