2. Lift the speakers straight up to remove them (2).
To install the speakers, reverse this procedure.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 6-10
Power connector cable description and part number
Description Spare part number
Power connector cable M21725-001
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 37).
2. Remove the bottom cover (see Bottom cover on page 37).
3. Disconnect the battery cable from the system board (see Battery on page 46).
Remove the power connector cable:
1. Move the antenna cables (1) that route over the right screw.
2. Remove the three Phillips M2.5 × 4.0 screws (2) that secure the right display hinge to the computer,
and then rotate the hinge off the power connector (3).
3. Disconnect the cable from the system board (4).
58
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
