Solid-state drive
Description Spare part number
Solid-state drive, 1 TB, PCle, NVMe, TLC L12805-001
Solid-state drive, 512 GB, SATA-3, FIPS 140-2 L12810-001
Solid-state drive, 512 GB, PCIe, NVMe, TLC L12811-001
Solid-state drive, 360 GB, PCIe, NVMe, TLC L12809-001
Solid-state drive, 256 GB, PCIe, NVMe, TLC, self-encrypting drive (SED), Opal 2 L12806-001
Solid-state drive, 256 GB, PCIe, NVMe, TLC L12807-001
Solid-state drive, 256 GB, PCIe, NVMe, value L12808-001
Solid-state drive, 256 GB, SATA-3, self-encrypting drive (SED), Opal 2 L12803-001
Solid-state drive, 128 GB, SATA-3, TLC L12804-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 33).
5. Remove the battery (see Battery on page 34).
Remove the solid-state drive:
▲
Remove the Phillips M2.0×3.0 screw (1), and then pull the solid-state drive module from the socket (2).
Reverse this procedure to install the solid-state drive.
Component replacement procedures 39
To Next Page
Loading...
