Smart card reader
Description Spare part number
Smart card reader board L09550-001
Smart card reader bracket (included in Bracket Kit) L09539-001
Smart card reader cable (included in Cable Kit) L09534-001
Before removing the smart card reader, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the following components:
a. Bottom cover (see Bottom cover on page 33)
b. Battery (see Battery on page 34)
c. Hard drive (see Hard drive on page 37)
d. Solid-state drive (see Solid-state drive on page 39)
e. WWAN module (see WWAN module on page 40)
f. Keyboard (see Keyboard on page 43)
g. Internal frame (see Internal frame on page 47)
Remove the smart card reader:
1. Disconnect the system board cable from the smart card reader board ZIF connector (1).
Component replacement procedures 59
To Next Page
Loading...
