Fingerprint reader assembly
Description Spare part number
Fingerprint reader assembly (includes cable) L09538-001
Fingerprint reader bracket (included in Bracket Kit) L09539-001
Before removing the ngerprint reader assembly, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Bottom cover (see Bottom cover on page 33)
b. Battery (see Battery on page 34)
c. Hard drive (see Hard drive on page 37)
d. Solid-state drive (see Solid-state drive on page 39)
e. WWAN module (see WWAN module on page 40)
f. Keyboard (see Keyboard on page 43)
g. Internal frame (see Internal frame on page 47)
h. System board (see System board on page 65)
Remove the ngerprint reader assembly:
1. Remove the Phillips M2.0×2.0 screw (1) from the ngerprint reader bracket.
2. Slide the bracket toward the right, and then lift the right side up and pull the bracket toward the right
and o the ngerprint reader board (2).
Component replacement procedures 71
To Next Page
Loading...
