To Next Page

To Previous Page

9-11

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Syntax: timesync sntp

Selects SNTP as the time synchronization method.

sntp unicast

Configures the SNTP mode for Unicast operation.

sntp server <ip-addr> [version]

Specifies the SNTP server. The default server version is

no sntp server < ip-addr >

Deletes the specified SNTP server.

Note Deleting an SNTP server when only one is configured disables SNTP unicast

operation.

For example, to select SNTP and configure it with unicast mode and an SNTP

server at 10.28.227.141 with the default server version (3) and default poll

interval (720 seconds):

ProCurve(config)# timesync sntp

Selects SNTP.

ProCurve(config)# sntp unicast

Activates SNTP in Unicast mode.

ProCurve(config)# sntp server 10.28.227.141

Specifies the SNTP server and accepts the current SNTP server

version (default: 3).

Figure 9-5. Example of Configuring SNTP for Unicast Operation

In this example, the Poll Interval and the Protocol

Version appear at their default settings.

Note: Protocol Version appears only when there is an

IP address configured for an SNTP server.

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510 and is the answer not in the manual?

HP ProCurve 2510 Specifications

General