RADIUS Authentication and Accounting
Viewing RADIUS Statistics
show radius authentication
Displays NAS identifier and data on the configured RADIUS
server and the switch’s interactions with this server.
(Requires prior use of the radius-server host command to
configure a RADIUS server IP address in the switch. See
“Configuring RADIUS Accounting” on page 6-48.)
Note: The Webui
access task shown in
this figure is available
only on the 5300xl
switches.
Figure 6-23. Example of Login Attempt and Primary/Secondary Authentication
Information from the Show Authentication Command
Figure 6-24. Example of RADIUS Authentication Information from a Specific Server
RADIUS Accounting Statistics
Syntax: show accounting
6-58
To Next Page
Loading...
