HP ProCurve 3400cl-24G Access Security Guide

Configuring Port-Based and Client-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
show port-access authenticator (Syntax Continued)
config [< port-list >]
Shows:
• Whether port-access authenticator is active
• The 802.1X configuration of ports configured as
802.1X authenticators (For descriptions of these
elements, refer to the syntax descriptions under
“1.
Enable 802.1X Authentication on Selected Ports” on
page 10-15. Use show running to view the current
client-limit configuration available for 5300xl
switches on software release E.09.xx or greater.)
Without < port-list >, the command lists ports configured
as 802.1X port-access authenticators. Does not display
data for a port not enabled as an authenticator.
statistics [< port-list >]
Shows:
• Whether port-access authenticator is active
• The statistics of the ports configured as 802.1X
authenticators, including the supplicant’s MAC
address, as determined by the content of the last
EAPOL frame received on the port.
Does not display data for a specified port that is not
enabled as an authenticator.
session-counters [< port-list >]
Shows whether port-access authenticator is active, and
includes the session status on the specified ports con
-
figured as 802.1X authenticators
Also, for each port, the “User” column lists the user
name the supplicant used in its response packet. (For
the switch, this is the identity setting included in the
supplicant
command—page
10-40.) Does not display
data for a specified port that is not an authenticator.
vlan [< port-list >]
Shows per-port:
■ The Access Control setting (control command on
page
10-16)
■ Unauth-VLAN ID (if any)
■ Auth-VLAN ID (if any)
10-43

HP ProCurve 3400cl-24G Specifications

General

Brand	HP
Model	ProCurve 3400cl-24G
Category	Switch
Language	English