HP ProCurve 6400cl Series - CLI Commands Described in this Section; Viewing the Switchs Current Authentication Configuration

TACACS+ Authentication
Configuring TACACS+ on the Switch
CLI Commands Described in this Section
Command Page
show authentication 5-9
show tacacs 5-10
aaa authentication pages 5-11 through 5-14
console
Telnet
num-attempts <1-10 >
tacacs-server pages 5-15
host < ip-addr > pages 5-15
key 5-19
timeout < 1-255 > 5-20
Viewing the Switch’s Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax: show authentication
This example shows the default authentication configuration.
l
le
Configuration for ogin and enable access
to the switch through the switch conso
port.
Configuration for login and enable access
to the switch through Telnet.
Figure 5-2. Example Listing of the Switch’s Authentication Configuration
5-9