EasyManuals Logo

HP ProCurve 6400cl Series Access Security Guide

HP ProCurve 6400cl Series
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #269 background imageLoading...
Page #269 background image
Traffic/Security Filters
Configuring Traffic/Security Filters
Configures the filter to drop traffic for the ports and/or
trunks in the designated < destination-port-list >. Can be
followed by forward < destination-port-list > if you have
other destination ports set to drop that you want to
change to forward. If no drop or forward action is speci
-
fied, the switch automatically creates a filter with a
forward action from the designated source port (or trunk)
to all destination ports (or trunks) on the switch.
[ forward ] < port-list >
Configures the filter to forward traffic for the ports and/
or trunks in the designated < destination-port-list >.
Because forward is the default state for destinations in a
filter, this command is useful when destinations in an
existing filter are configured for drop and you want to
change them to forward. Can be followed by drop < desti
-
nation-port-list > if you have other destination ports set to
forward that you want to change to drop. If no drop or
forward action is specified, the switch automatically
creates a filter with a forward action from the designated
source port (or trunk) to all destination ports (or trunks)
on the switch.
Example of Creating a Source-Port Filter
For example, assume that you want to create a source-port filter that drops
all traffic received on port 5 with a destination of port trunk 1 (Trk1) and any
port in the range of port 10 to port 15. To create this filter you would execute
this command:
ProCurve(config)# filter source-port 5 drop trk1,10-15
Later, suppose you wanted to shift the destination port range for this filter up
by two ports; that is, to have the filter drop all traffic received on port 5 with
a destination of any port in the range of port 12 to port 17. (The Trk1 destination
is already configured in the filter and can remain as-is.)With one command
you can restore forwarding to ports 10 and 11 while adding ports 16 and 17 to
the "drop" list:
ProCurve(config)# filter source-port 5 forward 10-11 drop
16-17
9-17

Table of Contents

Other manuals for HP ProCurve 6400cl Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 6400cl Series and is the answer not in the manual?

HP ProCurve 6400cl Series Specifications

General IconGeneral
BrandHP
ModelProCurve 6400cl Series
CategorySwitch
LanguageEnglish

Related product manuals