Getting Started
Sources for More Information
Figure 1-1. Example of a Figure Showing a Simulated Screen
In some cases, brief command-output sequences appear without figure iden-
tification. For example:
ProCurve(config)# clear public-key
ProCurve(config)# show ip client-public-key
show_client_public_key: cannot stat keyfile
Port Identity Examples
This guide describes software applicable to both chassis-based and stackable
ProCurve switches. Where port identities are needed n an example, this guide
uses the chassis-based port identity system, such as “A1, “B3-B5”, “C7”, etc.
However, unless otherwise noted, such examples apply equally to the stack
-
able switches, which typically use only numbers, such as “1”, “3-5”, “15”, etc.
for port identities.
Keys
Simulations of actual keys use a bold, sans-serif typeface with square brackets.
For example, the Tab key appears as
[Tab] and the “Y” key appears as [Y].
Sources for More Information
For additional information about switch operation and features not covered
in this guide, consult the following sources:
■ For information on which product manual to consult on a given software
feature, refer to “Product Documentation” on page v.
1-4
To Next Page
Loading...
Need help?
General