Removing an optical drive bezel blank
On some models, there is a bezel blank covering the slim optical drive bay. Remove the bezel blank before
installing an optical drive. To remove the bezel blank:
1. Remove the computer access panel and front bezel. See Removing the computer access panel on page 8
and Removing the front bezel on page 10.
2. To remove the bezel blank, press upward on the bottom tab (1), press downward on the top tab on the
side of the blank (2), rotate the blank o the front of the bezel (3), and then remove from the front bezel
panel.
Removing an optical drive bezel blank 11
To Next Page
Loading...
