NOTE: You must connect the primary hard drive data cable to the dark blue connector labeled SATA0 to
avoid any hard drive performance problems. If you are adding a second hard drive, connect the data
cable to one of the light blue SATA connectors.
9. Replace the computer access panel.
10. Reconnect the power cord and any external devices, and then turn on the computer.
11. Lock any security devices that were disengaged when the access panel was removed.
Installing a security lock
The security locks displayed below and on the following page can be used to secure the computer.
Security cable lock
32 Chapter 2 Hardware upgrades
To Next Page
Loading...
