Component identification 7
Item Description Status
1
Health status LED
bar
Solid Green = Normal (System is powered on)
Flashing Green = Power On/Standby Button service is being initialized
Flashing Amber = Degraded condition
Flashing Red = Critical condition
Off = Normal (System is in standby)
2
System power LED Solid Green = System is powered on.
Flashing Green = System is waiting to power on; Power On/Standby button is
pressed.
Solid Amber = System is in standby; Power On/Standby Button service is
initialized.
Off and the Health Status LED bar is off = The system has no power.
Off and the Health Status LED bar is flashing green = The Power On/Standby
Button service is being initialized.
3
UID LED Solid Blue = Identified
Flashing Blue = Active remote management
Off = No active remote management
4
FlexLOM LED Green = Network linked
Flashing Green = Network activity
Off = No link or activity
Drive LED definitions
Item LED Status Definition
1
Locate Solid blue The drive is being identified by a host application.
Flashing blue The drive carrier firmware is being updated or requires an update.
2
Activity ring Rotating green Drive activity
Off No drive activity
3
Do not remove Solid white Do not remove the drive. Removing the drive causes one or more of
the logical drives to fail.
Off Removing the drive does not cause a logical drive to fail.
4
Drive status Solid green The drive is a member of one or more logical drives.
Flashing green
The drive is rebuilding or performing a RAID migration, stripe size
migration, capacity expansion, or logical drive extension, or is
erasing.
Flashing
amber/green
The drive is a member of one or more logical drives and predicts
the drive will fail.
Flashing amber The drive is not configured and predicts the drive will fail.
To Next Page
Loading...
