Removal and replacement procedures 33
7.
Remove any expansion boards installed in the primary riser cage.
8. Remove the primary PCI riser cage.
Non-hot-plug drive carrier
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 29).
To Next Page
Loading...
