Removal and replacement procedures 59
7.
Remove the FlexibleLOM adapter from the riser cage.
To replace the component, reverse the removal procedure.
GPU
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 36).
5. Disconnect all cables connected to existing expansion boards.
To Next Page
Loading...
