Hardware options installation 32
Redundant hot-plug power supply option
To install the component:
1. Remove the power supply blank.
2. Install the power supply.
3. Connect the power cord to the power supply.
4. Connect the power cord to the AC power source.
Hard drive options
The server provides non-hot-plug capability through an embedded SATA controller. To obtain hot-plug
capability, install an optional controller and hot-plug cable option kit.
Hard drive guidelines
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all drive numbers.
• If only one hard drive is used, install it in the bay with the lowest drive number.
To Next Page
Loading...
