Hardware options installation 49
4.
Using a T-15 Torx screwdriver, install the internal USB connector.
5. Route and connect the internal USB cable to the system board.
6. Install the primary access panel.
7. Install the server into the rack.
SAS/SATA controller cable
Depending on the model purchased, the server may look different than shown.
1. Power down the server (on page 20).
2. Remove the server from the rack (on page 20).
3. Remove the primary access panel (on page 21).
4. Remove the secondary access panel (on page 21).
5. Remove the existing SATA cable.
To Next Page
Loading...
