Hardware options installation 58
4.
Remove the PCI riser board assembly (on page 23).
5. Install the cache module in the SAS cache module connector on the system board. For connector
locations, see "System board components (on page 11)."
6. Install the PCI riser board assembly (on page 24).
7. Install the access panel (on page 21).
8. Slide the server into the rack.
9. Power up the server (on page 19).
Installing the BBWC battery pack or the FBWC capacitor pack
1. Power down the server (on page 19).
2. Extend the server from the rack (on page 19).
3. Remove the access panel (on page 21).
4. Remove the PCI riser board assembly (on page 23).
5. Install the cache module ("Installing the cache module" on page 57).
CAUTION: When connecting or disconnecting the capacitor pack cable, the connectors on
the cache module and cable are susceptible to damage. Avoid excessive force and use
caution to avoid damage to these connectors.
6. Install the BBWC battery pack or the FBWC capacitor pack.
To Next Page
Loading...
