HP ProLiant DL360 G7 - Page 62

Hardware options installation 62
supply may be required. For more information, see the HP Enterprise Configurator website
(http://h30099.www3.hp.com/configurator/
).
To install the component:
1. Power down the server (on page 19).
2. Extend the server from the rack (on page 19).
3. Remove the access panel (on page 21).
4. If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 21).
5. Remove the air baffle (on page 22).
6. Remove the fan blank.
7. Install the fan module.
8. Remove the PCI riser board assembly (on page 23).
9. Remove expansion slot cover 2 from the PCI riser board assembly.