HP ProLiant DL360 SERIES - Installing an Expansion Board

Hardware Options Installation 59
5. Remove the expansion board.
Installing an Expansion Board
1. Power down the server ("Powering Down the Server" on page 25).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26
).
3. Remove the access panel ("Removing the Access Panel" on page 27
).
4. Remove the PCI riser board assembly.
5. Remove the expansion slot cover from the PCI riser board assembly.
6. Align the expansion board with the guiding groove.
7. Press to release the expansion board retainer clip.