HP ProLiant DL380 Generation9 (Gen9)
c04375627 – DA – 15034 North America — Version 7 — February 17, 2015
NOTE: The Primary GPU riser (719076-B21) is required to support this in slot1.
NOTE: The secondary GPU riser (719073-B21) is required to support this in slot2 (2nd
processor required).
NOTE: There are limitations on the server model and processor supported when
adding Graphics accelerators.
NOTE: This card will require the addition of the High Performance Fan Kit (719079-B21).
HP 150W PCI-E Power Cable Kit
NOTE: Each DL380 Gen9 server will accommodate up to three single-width or two double
width PCIe cards for Computational Graphics support. Note that 11.25" is the max length
for a card to also allow for cabling. This applies to primary slots 1 & 2 or secondary slots 4
& 5.
NOTE: The NVIDIA Tesla, GRID and Quadro modules are supported only on 64-bit versions
of Linux and Windows operating systems as well as on Virtual Machine client operating
systems. The supported bare metal operating systems are RHEL6, SLES 11 and Windows
Server 2012 R2.
NOTE: There are limitations on fan types, setting, and server model support by card.
NOTE: Mixing of GPUs is not supported.
HP DL380 Gen9 High Performance Fan Kit
NOTE: High Performance Fan kit consists of 6 fans, these will need to replace all the
standard Fans in the unit, and fill all 6-Fan cages.
NOTE: The 12LFF and 24SFF server models (including field upgrades to 24SFF) will already
include 6 High Performance Fan kits.
NOTE: The High Performance Fan Kit is needed to support certain Passive GPGPU (Graphics
cards) configurations; or ASHRAE operating environments.
NOTE: For elevated ambient temperature support please see:
http://www.hp.com/servers/ASHRAE.
To Next Page
Loading...
