HP ProLiant DL380 Generation9

QuickSpecs
HPE ProLiant DL380 Generation9 (Gen9)
Core Options
Page 51
NOTE: Maximum 2 supported with both risers, support for 2 cards requires the
1400W Power Supply (720620-B21) to be selected.
NOTE: The Primary GPU riser (719076-B21) is required to support this in
slot1.
NOTE: The secondary GPU riser (719073-B21) is required to support this in
slot2 (2nd processor required).
NOTE: This card will require the addition of the High Performance Fan Kit
(719079-B21).
NOTE: This is supported in an 8SFF model only.
NOTE: Max cooling setting required to support in RSBU.
HP AMD FirePro W7100 Accelerator Kit
NOTE: This is supported in all server models.
NOTE: The secondary GPU riser (719073-B21) is required to support this in
slot2 (2nd processor required).
NOTE: Up to 3 of these single wide cards are supported.
NOTE: 1x 1400W PS recommended, but this card will work with 1x800W PS
(Per GPU). However check the power usage via the HPE Power Advisor Tool
located at http://www.hp.com/go/hppoweradvisor.
J0H10A
HP AMD FirePro S9150 Accelerator Kit
NOTE:
For doublewide GPU support you are required to have at least 1x1400W
Power Supply (720620-B21), per card.
NOTE: The Primary GPU riser (719076-B21) is required to support this in
slot1.
NOTE: The secondary GPU riser (719073-B21) is required to support this in
slot2 (2nd processor required).
NOTE: There are limitations on the server and processor supported when
adding Graphics accelerators.
NOTE: This card will require the addition of the High Performance Fan Kit
(719079-B21).
NOTE: This card is supported on the E5-2600v3 series processors only.
NOTE: 12LFF support is restricted to 30C Server Ambient only.
J0H11A
HPE AMD FirePro S7150x2 Accelerator Kit
NOTE: For doublewide GPU support you are required to have
at least 1x1400W
Power Supply (720620-B21), per card.
NOTE: The Primary GPU riser (719076-B21) is required to support this in
slot1.
NOTE: The secondary GPU riser (719073-B21) is required to support this in
slot2 (2nd processor required).
NOTE: There are limitations on the server and processor supported when
adding Graphics accelerators.
NOTE: This card will require the addition of the High Performance Fan Kit
(719079-B21).
NOTE: This card is supported on the E5-2600v4 series processors only.
NOTE: This card only runs at PCIeGen2 speeds.
M3X68A
HP 150W PCI-E Power Cable Kit
NOTE: This cable is required for the K1, K4200, K5200, M5000 and W7100
cards.
669777-B21
NOTE: Each DL380 Gen9 server will accommodate up to three single-width or two double width PCIe
cards for Computational Graphics support. Note that 11.25" is the max length for a card to also allow
for cabling. This applies to primary slots 1 & 2 or secondary slots 4 & 5.