Server callouts
Item Description Color
1 Hot-pluggable PCI-X expansionslot 3, N/A
slot 3, 64-bit/100 MHz, Bus B
2 Hot-pluggable PCI-X expansion slot 2, N/A
slot 2, 64-bit/100 MHz, Bus B
3 PCI-X hot pluggable expansion slot 1, N/A
64-bit/133 MHz, Bus A
4 Serial connector Teal
5 iLO connector N/A
6 Mouse connector Green
7 Power cord connector N/A
8 Keyboard connector Purple
9 NIC 1 connector N/A
- NIC 2 connector N/A
q USB connectors Black
w Video connector Blue
e VHDCI SCSI connector (port 1) N/A
To register your product visit the HP Registration website at:
http://www.register.hp.com
Registering the server
CAUTION: Always install the heaviest item first, and
continue to populate the rack from the bottom to top.
1. Install the server and cable management arm. Refer to the
installation instructions that ship with the 2U Quick Deploy Rail
System.
• If you chose not to install the cable management arm, install
the power cord anchor to the server.
Installing the server into a rack
IMPORTANT: When using cable management arm components, be sure
to leave enough slack in each of the cables to prevent damage to the
cables when the server is extended from the rack.
If using the power cord anchor, be sure to leave enough slack in the
power cord so that the redundant power supply can be removed without
disconnecting the power cord from the primary power supply.
2. Connect any peripheral devices.
3. Connect the power cord to the back of the server.
4. Secure cables to the cable management arm if installed.
5. Connect the power cord to the AC power source.
WARNING: To reduce the risk of electric shock or damage
to the equipment:
• Do not disable the power cord grounding plug.
• Plug the power cord into a grounded (earthed) electrical
outlet that is easily accessible at all times.
• Unplug the power cord from the power supply to
disconnect power to the equipment.
• Do not route the power cord where it can be walked on or
pinched by items placed against it.
To Previous Page
Loading...
