8.
Remove the three T-10 Torx screws, and then detach the front bezel.
To replace the component, reverse the removal procedure.
Power supply cage assembly
To remove the component:
1. Power down the server (on page 26).
2. Access the product rear panel (on page 27).
3. Remove all power supplies ("Hot-plug power supply" on page 30).
4. Remove the server from the rack (on page 27).
5. Remove the access panel ("Access panel" on page 32).
6. Remove the PCI riser cage ("PCI riser cage" on page 36).
7. Remove the air baffle ("Air baffle" on page 42).
8. Remove the power supply backplane ("Power supply backplane" on page 34).
9. Loosen the system board thumbscrews, and then slide the system board assembly forward.
Removal and replacement procedures 54
To Next Page
Loading...
