HP ProLiant DL385 G6 - Page 55

10.
Remove the power supply cage assembly.
To replace the component, reverse the removal procedure.
System board
To remove the component:
1. Power down the server (on page 26).
2. Remove all power supplies ("Hot-plug power supply" on page 30).
3. Extend or remove the server from the rack ("Extend the server from the rack" on page 25, "Remove
the server from the rack
" on page 27).
4. Remove the access panel ("Access panel" on page 32).
5. Remove the PCI riser cage ("PCI riser cage" on page 36).
6. Remove the battery pack ("Removing the battery pack" on page 41).
7. Remove the air baffle ("Air baffle" on page 42).
8. Remove the power supply backplane ("Power supply backplane" on page 34).
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser cage.
9. Remove the hot-plug fans from the fan cage ("Hot-plug fan" on page 33).
10. Remove the fan cage ("Fan cage" on page 43).
11. Remove all DIMMs ("DIMMs" on page 50).
12. Remove the heatsink ("Heatsink" on page 43).
Removal and replacement procedures 55