Item Description
10 System maintenance switch
11 Power supply backplane connector
12 Processor 1 socket
13 Primary riser connector
14 Secondary riser connector
15 Diagnostic LEDs
16 Processor 2 socket
17 Processor 2 DIMM slots
18 Fan 6 connector
19 Fan 5 connector
20 Fan 4 connector
21 Fan 3 connector
22 Fan 2 connector
23 Fan 1 connector
System board switches
tenance switch System main
Position Default Function
S1 Off Off = iLO 2 security is enabled.
On = iLO 2 security is disabled.
S2 Off Off = System configuration can be changed.
On = System configuration is locked.
S3 Off Reserved
S4 Off Reserved
S5 Off Off = Power-on password is enabled.
On = Power-on password is disabled.
S6 Off Off = No function
On = ROM reads system configuration as invalid.
When the system maintenance switch position 6 is set to the On positi
all system configuration settings from both CMOS and NVRAM.
on, the system is prepared to erase
CAUTION: Clearing CMOS and/or NVRAM deletes configuration
RBSU setting that erases default settings and fixed disk partitions, whic
information. There is an
h causes a loss of data.
Diagnostic LEDs
Position Position Function
S7 S8 Diagnostic LEDs
Off Off Port 85
Off On Port 84
Component identification 73
To Next Page
Loading...
